background image

      DANGER

:

 Electrical Shock Hazards.

•  Only qualified persons should operate  the MAXIS

® 

3K

•  Wear eye protection, hard hat, cut resistant gloves and safety 
    toe shoes when using this tool.
•  Do not use tool while tired or under the influence of drugs, 
    alcohol, or medication.
•  Keep body parts and loose clothing away from moving parts.
•  Always follow operating procedures.
•  Avoid accidental starting. Make sure switch is off before 
    plugging in motor.

 

•  Do not expose power tools to rain or wet conditions. Water 
    entering a power tool can increase the risk of electric shock.
•  Plug into a (GFCI) ground fault interrupted circuit outlet only.
•  Use a 10/3 20 Amp 120 Volt extension cord no more than 100 
    feet in length.
•  Maintain proper care of power cords. Do not use the cord to 
    carry the tool or pull the plug from an outlet. Replace damaged 
    cords immediately. Damaged cords can increase the risk of 
    electric shock.
•  Do not use this tool near live circuits. Shut off and lock out 
    power when working near existing circuits.

FAILURE TO OBSERVE THESE WARNINGS COULD 

RESULT IN SEVERE INJURY OR DEATH.

WARNING

 - Personal Safety Hazards

WARNING

•  Read and understand all instructions and safety information in 
    this manual before operating or servicing this tool. 
•  Read the instruction manual supplied with your drill before 
    operating the Maxis® 3K puller.
•  Failure to observe these warnings could result in severe injury 
    or death.

3

IMPORTANT SAFETY INFORMATION

FAILURE TO OBSERVE THESE WARNINGS COULD 

RESULT IN SEVERE INJURY OR DEATH.

     WARNING

:

 Tool Use Hazards

•  Use this tool for the manufacturers intended purpose only. 
    Use other than that described in this manual can result in injury 
    or property damage.
•  Do not use nylon or polypropylene rope, extreme force can be 
    stored when rope stretches.

4

IMPORTANT SAFETY INFORMATION

     WARNING

:

 Entanglement Hazard

     WARNING

:

Tipping

•  Do not operate this tool while wearing loose-fitting clothing. 
    Retain long hair.
•  Keep hands away from the puller’s capstan. Rope at the capstan 
    can crush a hand.
•  Turn off drill when wrapping rope on capstan.

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT

IN SEVERE INJURY OR DEATH. 

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT

IN SEVERE INJURY OR DEATH. 

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT

IN SEVERE INJURY OR DEATH. 

•  Use the appropriate size adaptor with conduit. Lock adaptor 
    under conduit nut. Disassemble when not in use.

Содержание M3K-M











Отзывы: