SPECIFICATIONS
TROUBLESHOOTING
Lights do not come on at all:
1. Make sure the breaker for the fuse is in the on position.
2. Make sure the switch in the house is turned on.
3. Check to see there is power to the motion detector on the black and white wires from
the house.
4. Make sure the lamps being used are working. Faulty bulbs, or fiber washer at bottom
of screw-type bulbs will prevent proper contact.
5. Check all wiring and connections.
A: All white wires
B: Black house wire to black motion detector wire.
C: Ground wires.
Lights stay on all night
1. The dusk-to-dawn photocell feature. Make sure daylight is normal (N) position for
motion detection.
2. Check all wiring and connections.
A: All white wires
B: Black house wire to black motion detector wire.
C: Ground wires.
3. Check to make sure each lamp is minimum 40 watts and total does not exceed
total 500 Watts.
Motion Detector triggers on with motion, and stays on:
1. Move floodlights away from motion detector head, or use lower wattage lamps.
2. If mounted on slope, aim slightly upward if slope is upward. If on downward slope,
aim motion detector head severely downward, and slowly raise if necessary. Adjust
during day using test mode.
3. Adjust Range sensitivity adjustment. Do not use this adjustment to compensate for
poor aiming.
Sensor Range
Up to 70 ft.(21m)
Sensing Angle
180 Downward detection
Power Consumption
4 watts maximum(control module only)
Power Requirement
110/120 volts 60 Hz
Load Rating
500 watts maximum (Incandescent only)
Operating Modes
TEST, AUTO, MANUAL, and Temperary ON Mode
Delay Control
30 seconds to 10 minutes (approximately)
LED Indicator
1 piece LED for Test Mode indicator & intruder watcher
