Questions? Call Toll Free at 1-800-737-2112
Copyright © 2011 MAT Engine Technologies, LLC
Storage
NOTE: To prevent fuel gum deposits in the Blower/Vacuum/Mulchers carburetor and fuel system, it is acceptable to use
fuel stabilizer.
Follow the stabilizer manufacturer’s instructions. Run the engine at least 5 minutes after adding stabilizer.
Spark Plug:
B
Inspect the spark plug after every 10-15 hours of use; adjust spark plug gap and replace spark plug as necessary. Replace
spark plug every year to maintain engine performance and easy starting.
To inspect or replace the Spark Plug:
1. Remove the insulated spark plug boot.
2. Use the spark plug wrench to remove the Spark Plug, by
turning counter-clockwise.
3. Clean and adjust the spark plug gap to 0.024 – 0.028 in.
(0.6 - 0.7mm).
4. Replace any worn plug with a recommended
replacement (see
PRODUCT SPECIFICATIONS. Clean
and adjust the spark plug gap to 0.024 – 0.028 in. (0.6 -
0.7mm).
5. Install the Spark Plug finger tight in the cylinder head,
then tighten firmly with the spark plug wrench.
6. Replace the insulated spark plug boot.
1. Allow engine to cool and empty the fuel tank before
storing or transporting in vehicle. Use up remaining fuel
in the carburetor by starting the engine and letting it run
until it stops.
2. When not in use, store Blower/Vacuum/Mulcher indoors
in a dry location. Store Blower/Vacuum/Mulcher above
the reach of children or in a locked area out of the reach
of children.
3. Store unit and fuel in area where fuel vapors cannot
reach sparks or open flames from water heaters, electric
motors or switches, furnaces, etc.
4. When preparing the Blower/Vacuum/Mulcher for storage
or when Blower/Vacuum/Mulcher will not be used for 30
days or more:
a. Inspect and clean the Blower/Vacuum/Mulcher
thoroughly.
b. Lightly oil all external metal surfaces.
c. Remove the spark plug, place a few drops of
2-cycle engine oil into the cylinder. Pull the
recoil starter several times to distribute the oil.
Replace the spark plug.
d. Inspect and clean air filter as required.
Routine Maintenance
• Save all instructions
Air Filter:
A
Accumulated debris and dust in the air filter will reduce engine performance, increase fuel consumption, and increases the
risk of engine damage. Clean the air filter every 5 hours of operation.
Fig. 20
WARNING
Disconnect the spark plug before performing maintenance except for carburetor adjustments.
1. Before removing Air Filter Cover, brush away any loose
dirt or debris on and around the filter cover.
2. To remove Air Filter Cover, press on its sides and lift off.
(Fig. 20)
3. Remove and clean foam filter.
• Light surface dust can readily be removed by tapping the
filter.
• Heavy deposits should be washed out with soap and
water. Squeeze out any remaining water and allow the
filter to completely dry.
WARNING
Never clean filter in gasoline or other flammable solvents.
4. Add a drop of thin oil to the filter and replace it.
10
