Page 16 of 21
Installation & Adjustment Procedures
6.2.2. Worm gear operator (SEGO – Safety Enhanced Gear Operator) (Optional)
6.2.2.1. The weight of the vertical operating pipe should be supported by pipe
collar by maintaining the ¼”-3/8” gap.
6.2.2.2. When the switch is properly adjusted the operator handle should hang
freely in both the open and closed positions to permit the use of the
customer supplied padlock.
Figure 17: Type SEGO (Safety Enhanced Gear Operator)
6.2.3. Swing handle operator
6.2.3.1. Adjust stops on handle mount after adjusting switch.
6.2.3.2. When the switch is properly adjusted the handle should hang vertically and
free in both the open and closed positions to permit the use of a customer
supplied padlock.
6.2.4. Electrical motor operator
6.2.4.1. Please refer to motor operator instruction manual for proper installation and
setup.
6.2.4.2. Use manual operation while completing switch setup.
Be aware that there is an adjustable stop on the operator.
Do not over operate
as damage will occur to the operator.