South Shore Ezra 14580, Сборка, Страница: 11 / 28

VRXWKVKRUHIXUQLWXUHFRP
IMPORTANT
GUIDELINES TO ASSURE SAFE AND PROPER OPERATION OF YOUR TABLE
INSTALLATION: Please always follow these instructions!
1- Never open the A/C Control box.
2- Only use supplied power cable.
3- Do not install table on an uneven surface.
4- Do no install table in dusty or humid locations.
5- Never lean on or apply excessive weight to table while in operation.
6- Prevent wires from becoming caught in the mechanisms by securing them with the supplied clips and ties.Keep
motor area clear from wires and any other objects at all times.
7- Only use a dry or damp clothto clean control box. Before cleaning UNPLUG from power source.
8- Check that all connectors are securely plugged in; remote wire and motor(s) wire(s) and A/C control box.
RESET INSTRUCTIONS
Press and hold the ''
¶
'' button. The table will descend to its lowest level, stop, and rise until reaching default height -
the readout will now show height in inches/cm (normally 24.0) instead of << ASF >>.
LOWEST LEVEL POSITION MUST BE REACHABLE. Path must be clear of obstructions when lift table is descending it
cannot hit a stop before LOWER LEVEL position otherwise reference is stored at the wrong height.
After
RESET
, run full up and down cycles several times to ensure problem is solved.
LOCKING / UN-LOCKING the remote keypad
''LOC'' = Remote is locked. To unlock, press UP+DOWN same time about 5 seconds.
Same procedure to lock.
OTHER ISSUES AND SOLUTIONS
IF ONE LEG is higher than the OTHER
1- Unplug power.
2- Swap the left motor connector with the right motor connector on the A/C control box.
3- Repeat
RESET
procedure.
IF THERE IS NO CHANGE
The problem is with the MOTOR LEG..
IF THE CHANGE RESULTS IN THE SAME PROBLEM BUT WITH THE OTHER LEG
The problem is with the A/C CONTROL BOX..