South bend SB1093, Руководство пользователя

Страница: 28 / 52

-26-
For Machines Mfd. Since 10/20
South Bend Tools
Model SB1093
O P E R A T I O N
5.
Position table/fence assembly over spacer
plate and re-install mounting bolts and
washers (see Figure 34 ).
Figure 34. Fence mounting position.
Note:
The back stop is intended to keep the
workpiece from being thrown from the belt. It may
be removed for longer work pieces and to perform
'through-sanding' operations however, the back
stop should immediately be re-installed after this
type of operation.
1. DISCONNECT MACHINE FROM POWER!
2. Make sure sanding belt is tensioned correctly
(see Tensioning Sanding Belt on Page
30 ).
8. While holding back end of workpiece against
backstop and fence with both hands, and
while keeping your fingers away from belt,
slowly feed workpiece into belt, as shown in
Figures 36 — 37 .
Note: The belt sander can also be used with
the fence removed however, the back stop
must remain installed.
Figure 36. Example of sanding face of workpiece in
horizontal position.
3. Make sure belt tracking is correctly set (see
Tracking Sanding Belt on Page 31 ).
4.
Adjust angles of fence, if necessary, for
operation.
5. Turn sander and dust collector ON.
6. Place workpiece firmly against fence.
7. Slowly move workpiece into sanding belt.
Figure 37. Example of sanding edge of workpiece in
horizontal position.
6.
Position fence in desired position, then
tighten mounting screws (see Figure 35 ).
Figure 35. Fence installed.
Fence
Backstop
Performing Horizontal Edge
Sanding