South bend SB1093, Руководство пользователя

Страница: 27 / 52

South Bend Tools
For Machines Mfd. Since 10/20 Model SB1093
-25-
O P E R A T I O N
Horizontal Sanding
If the belt sander is in the vertical position,
follow the steps, "To set up sander for horizontal
sanding
"
below, to set up the sander for
horizontal sanding. If the sander is already
in the horizontal position, skip ahead to "
To
perform horizontal or edge sanding"
on Page
26 .
Setting Up Sander For Horizontal
Sanding
Note: To use the belt sander in the 45° position,
leave the indexing pin engaged at 45° point and
tighten the tilt lock lever. Loosen the tilt lock knob
to adjust the table if necessary (see Figure 31 ).
3. Remove (2) cap screws and (2) washers and
remove table assembly (see
Figure 32
).
Figure 32. Table assembly mounting screws.
Figure 31. Belt sander in 45° position.
4. Loosen table/fence spacer plate and rotate
180° to align with upper holes; re-tighten
spacer plate (see Figure 33 ).
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen belt sander lock lever by turning
clockwise, then pull indexing pin out and
carefully tilt belt sander to desired position;
tighten tilt lock lever (see
Figure 30
).
Note: The indexing pin will snap into locked
position at 45°. Simply pull the indexing pin
back out to continue tilting to 90°.
Figure 30. Tilting belt sander.
Tilt Lock
Lever
Index Pin
Figure 33. Rotating spacer plate.
x2
Table/Fence
Assembly
Connecting Screw