Source Audio Collider Delay+Reverb, Руководство пользователя, Страница: 19 / 51

SA263
Collider Delay+Reverb Owner’s Manual
19
Control Input Jack Assign Options : To toggle between Control Input Jack assignments, unplug
the power cable. Then, press + hold the CONTROL INPUT Button while plugging the power
supply back in. Keep holding the CONTROL INPUT Button to cycle through the options. The
Control LED Indicator will flash once for Option 1 (Neuro Hub/Expression), twice for Option 2
(Preset Increment), three times for Option 3 (Preset Decrement), and four times for Option 4
(Tap). Release the CONTROL INPUIT Button to select one of these four options.
Preset Select/(Hold) Save Button and LEDs
Press the SELECT button to scroll through and select saved user presets. The four P
RESET
LED
S
next to
the P
RESET
B
UTTON
indicate which preset is active for presets 1 through 4. If a preset has been
modified, the corresponding P
RESET
LED will blink slowly. To save a preset, press and hold this button
–
the associated preset LED will blink for a few seconds. When the LED stops blinking, the updated
preset will be saved to the current preset position.
Preset Extension Mode : Allows for easy access to an additional 4 presets for a total of 8 onboard
presets. To enable Preset Extension Mode, go to the Hardware Options sections of the Neuro Mobile
or Desktop Editor (see
Neuro Hardware Options ) and select the appropriate option. The illumination
patterns of the Preset Select LEDs indicate which Preset has been selected (see the figure below).
Preset Extension Mode can also be enabled as a hardware shortcut on the Collider itself. To Enable
Preset Extension Mode, hold down the CONTROL INPUT press the PRESET SELECT button.
Note: when using a MIDI controller to select a preset outside of the normal bank (presets 1 to 4) or
extended bank (presets 5 to 8), then all 4 P
RESET
LED
S
will be lit, indicating that a preset in the range
between 9 and 128 is active. For details on preset editing and saving, see the next section.
Preset Storage and Recall
User Presets store all user editable parameters. This includes the knob positions, current effect
engines, routing options, external control, and the full list of Neuro/MIDI accessible parameters.
Included in every preset are settings for either position of the KNOBS Switch (Delay or Reverb). After
a preset is recalled, you can always tweak it in a performance situation by turning a knob. The knob
parameter will then
“jump” to the
knob position as the knob is moved.
Recalling Presets
The first 4 User Presets (or 8 in Preset Extension Mode) are accessible via the onboard hardware or
with and external footswitch in the following ways: