Installation
1. Make sure the ignition i s turned off, and
disconnect the cable from the vehicle battery’s
negative (-) terminal.
You never want electricity running while you
install this 2-DIN car receiver.
2. Before installation, disconnect the wire harness
and the antenna.
3. Attach the brackets on the both sides of the car
receiver with screws as shown as the above figure.
4. Consult with your nearest dealer if installation
requires the drilling of holes or other modification of
the vehicle.
5. Install the car receiver in the dashboard.
6. Connect the wire harness & antenna to the car
receiver being carefully not to pinch any wires or
cables.
7. Install the plastic outer trim ring onto the car
receiver.
8. Reconnect the battery and run through all of the
options on this car receiver to ensure that everything
is working correctly.
9. Particulars will vary widely depending upon the
kind of your car and the car you intend to install it in.
Please choose the correct installation method
according to the actual situation of your car. Always
contact the car dealer or manufacturer if you have
any questions.
Note:
Note: The parking wire is connected with brake
signal; for safety, the programs can be seen on
the monitor after braking the car.
Connecting the revising line to taillight on the
car.
After connection, when you start up the reverse
gear, the unit will receive the picture from car
rear view camera.
Parking Wire
Speaker connection
Note:
1. Only use groudless loudspeakers
2 Use only loudspeakers of munimum 40 Watt,
using fewer watts may result in damaging
your loudspeakers at higher volumes.
3.Use 4-8 ohm impendace loudspeakers only,
suing higher or lesser inpendance may
damage the unit.
4.Do not use 3-cable loudspeakers and do not
connect the loudspeakers mumis to the car.
The unit is using a BTL circuit and eachloud-
speaker must be connected
with insulated cables according the diagram.
5. Loudspeaker cables and/or optional external
power amplifiers must always be about 30 cm
away from the antenna and/or antenna
extension parts.
Connect the speakers accordind the following
diagram,incorrect connections will damage
the unit or your loudspeakers.
Installation
4
