1. Offer the doorset up to the opening.
2. Hold the frame in place using wedges, ensuring the frame is square. A large (5ft/1.5m
recommended) spirit level should be used to ensure that all jambs are square and plumb.
Please note, the Ecoframe is supplied fully finished and care must be taken not to damage the
surface of the frame during installation
3. After ensuring the hinge jamb is square and plumb by re-adjusting the wedges if necessary, fix the hinge jamb in four positions (as shown).
5. Cut off the wedges to align with the edge of
the frame. Take care not to damage the surface
of the Ecoframe.
6. Fill the gaps between the frame and wall
with a suitable fire resistant infill and
sealant capping.
4. Close the door and position the closing
jamb so that it makes full and uniform contact
with the frame seal. Then fix (as step 3).
fax:
0844 371 5333
www.premdor.co.uk
tel:
0844 209 0008
For installation support or further information
Doorset Installation
