13
ENGLISH
LIGHTBLASTER 1200 CMZ User manual
8.1. FUNCTIONS DESCRIPTION
All the LIGHTBLASTER 1200 CMZ functions are selectable by using the UP BUTTON and
DOWN BUTTON on the Control Panel as described in “7.1. Control Panel” on page 11.
Below is an explanation of the device’s functions.
1) DMX CHANNEL SELECTION
After the selection of
function, by pressing ENTER button, it is possible to
select the desired DMX Channel in order to manage the device using a DMX controller.
Once the channel is selected, press the ENTER button to confirm the value.
The range of this parameter is A001 -> A512
2) RUN MODE SELECTION
After the selection of
function, by pressing ENTER button, it is possible to
select the device Run Mode by using the [UP] and/or [DOWN] buttons:
-
AUTO Mode
: The device automatically run according to built-in program.
The display shows
.
-
SOUND Mode
: If the Sound Mode is selected and the integrated micro-
phone detects sounds, the device will run automatically
according to the built-in program. The display shows
.
-
SLAVE Mode
: Using this mode, it is possible to connect several units togeth
er and operate them in synchronized mode.
Use DMX cables to connect two or more units together from
the DMX OUT connector to the DMX IN connector.
The first unit is MASTER and all the connected units must be
set as SLAVE. The display shows
.
Set the Master unit in AUTO Mode or SOUND Mode to
operate the entire system. The entire chain of Slave units will
act as the Master unit.
3) DMX CHANNELS NUMBER CONFIGURATION
LIGHTBLASTER 1200 CMZ can be configured with two channel modes in order to be
managed by a DMX controller. The function that allows the selection of the mode is
. The two possible modes are
7Ch
and
18Ch.
Press the ENTER button to
confirm the selected mode.
Note: If the device is not connected to a DMX control unit, the main screen
will flash. By pressing the [ENTER] button, the device will access the
main menu.
