soundsation 12AX HYPER-PRO TOP 15AX, Руководство пользователя

Страница: 8 / 32

8
ENGLISH
Hyper-PRO top AX series User manual
2)^AC MAINS SELECTOR
This selector allows you to select the input supply voltage. It is protected by a Plexiglas
cover to prevent an accidental and incorrect voltage selection.
3)^POWER Switch
Press the switch to the ON position to turn the speaker on and to the OFF position to
turn it off.
4)^HPF Switch
This switch allows to select the cutoff frequency of the high pass filter. Placing this
switch on [120Hz] will cut the low frequency components below the threshold. If the
unit is used independently, the switch must remain in position [OFF]. If you intend to
use the unit in combination with a sub-woofer, we recommend that you set this switch
to [120Hz].
5)^LIMIT INDICATOR (LED)
This LED (red) indicates that the limiter is on when the output voltage of the amplifier
exceeds the maximum level, or when power overload is detected. Some flashing of this
LED may be normal, but if it stays on for a long time, lower the input level.
6)^FRONT LED SWITCH
This switch allows to turn ON/OFF the Blue front LED.
7)^DSP PRESETS PANEL SECTION
In this panel section it is possible to change the speaker response adjusting the timbre
to the relevant applications. By pressing the PRESET switch, it is possible to scroll the
following modes:
f
LIVE: The ideal preset for most “live” application.
f
DJ: Recommended for installations in discos and clubs.
f
SPEECH: The speaker allows the best speech intelligibility.
f
MONITOR: The speaker becomes specially suited for use as “stage monitor”.
The selected mode will be indicated by the relative LED.
8)^MIC/LINE 1 INPUT PANEL SECTION
In this panel section there is a connector (female XLR-type) that accept balanced MIC or
LINE level signals. By using LINE/MIC switch it is possible to adapt the gain to micro-
phone or line level signal; The LEVEL knob allows to adjust the input signal level.
The THRU connector (male XLR-type) produce exactly the same signal that arrive in the
input . Use it to daisy-chain several HYPER-PRO TOP AX speakers.
NOTE: Please notice that the input connector do not 48V Phantom
Power, so you can use condenser microphones only if self-powered.