EVCS_Remote Node_ENGND04101 1.15
1.800.338.7337 / www.soundoffsignal.com
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage. To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support
. If you have questions regarding this product, contact
Technical Services
, Monday - Friday, 8 a.m. to 5 p.m. at
1.800338.7337
(press #4 to skip the
automated message). Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
3
Wiring and Interconnect Requirements for ENGND04101 Remote Node
•High current interconnects require careful termination with the proper equipment.
WARNING! Poor crimp quality can cause significant heat build-up and fire.
Follow connector
manufacturer instructions to terminate properly.
•Remote Node can switch up to a
total maximum of 50Amps.
User must configure outputs to not exceed this total current. Individual output switches are rated up to 10Amps each for higher
current loads,
but the total device current must not exceed 50Amps.
The software warns when these limits are exceeded and user must ensure that individual output limits and total device
current limits are not exceeded in normal use.
•
Do not gang or parallel multiple outputs to drive a high current load.
Multiple 5Amp and 10Amp outputs must not be combined to achieve a higher current limit.
TERMINATION OPTION 2
Purchase individual connector components to terminate the wires at the connector.
Molex P/N:
19418-0030
Molex P/N:
19420-0001
Molex P/N:
19417-0119
MX150L™ 16 Circuit Sealed
Receptacle for 14-16 AWG Wire
MX150L™ Female Terminal for 14-16 AWG
Wire, Tin Plated
MX150L™ Socket Plug/Key (One plug re-
quired for each unused pin location to seal)
•MX150L Assembly Instructions: http://www.molex.com/pdm_docs/as/AS-19417-001.pdf
•Application Tooling Specification Sheet: http://www.molex.com/pdm_docs/ats/ATS-6381144HM.pdf
•Quality Crimping Handbook: http://www.molex.com/pdm_docs/ats/TM-638000029.pdf
•Actual terminal and housings may be different depending on application, wire type, etc.
•
Hand Crimp Tool:
Molex P/N:
63811-4400
•Manual Extraction Tool:
Molex P/N:
63813-1500
•WARNING! Wire diameter with insulation must be 0.113in to 0.139in (2.87mm-3.53mm) to properly seal
(such as SXL 16AWG)
Pros:
•Consistent wire colors, clean install without butt-splices
Cons:
•Need to purchase crimper and train personnel
WARNING
TERMINATION OPTION 1
Purchase accessory mating harness from SoundOff Signal
SoundOff P/N:
ENGHNK02 (16pin Mating Harness)
•
Typically a water tight butt--splice with glue is used to
protect this termination and is required for exterior use.
Pros:
•
No need to terminate at the connector pins
•No need to purchase Molex crimper
Cons:
•Requires butt-splice or alternate connector
•Requires heat shrink tubing with glue for exterior
Strip to this length
(drawn to scale)
0.165” to 0.197”
Insulation
Crimp
0.006” to
0.026”
