1.800.338.7337 / www.soundoffsignal.com
6
7X3 / 6X4 P SERIES_STT
00KPJL 0822 REV B
STUD MOUNT INSTALLATION:
1. Drill (2) 1/4" holes to mount light and 3/4" wire hole (see
Fig. 7)
.
The drill template shown is compatible with both the the 6x4 and
7x3 stud mount light.
2. Thread studs into the back of light.
3. Place bezel over front of light.
4. Align the gasket to the mounting surface. Horizontal and vertical
orientations are indicated on gasket for proper seal.
5. Press light/bezel assembly against gasket, against mount surface.
6. Secure the light to mounting surface using (2) supplied nuts, on
the back side of vehicle mount surface.
NOTE
: Tighten until gasket is compressed. DO NOT over tighten
and strip casting threads.
DO NOT USE POWER TOOLS TO
TIGHTEN.
8. Plug the wire harness into the back of the light. Reference
page 8
for retention clip installation.
DRILL FOR WIRE EXIT
DRILL FOR STUD MOUNT
CL
FIG. 7
NOT TO SCALE, FOR REFERENCE ONLY
FIG. 6
6X4 STUD MOUNT LIGHT PICTURED
GASKET
WIRE HARNESS
NUTS
STUDS
WIRE HOLE
