SCD1990SW
/ English Instruction Manual
4
NOTE:
If there is no DAB+ reception at any time, change the position of the unit or adjust the antenna.
Press and hold the “AMS/MODE” button for approx. 3 seconds to start a new search.
In DAB mode, press the
“STOP/MENU” button to enter the DAB menu.
The DAB menu is divided into menus: Full scan, Manual tune, DRC, Prune and System.
•
Full scan:
Starts the station scan. The DAB frequency band is scanned for stations.
•
Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. Select individual frequencies using the
“ENTER / PLAY / PAUSE /
CLOCK
” button.
•
DRC:
Short for Digital Range Control (dynamic range). The term DRC describes the ratio between
the quietest and the loudest sound. If the dynamic range is very high there are very soft
sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
This however has the disadvantage that the loud sections become uncomfortably loud. It
makes sense here to reduce the dynamic range. Select between the options:
-
DRC off: The dynamic range is not reduced.
-
DRC high: The dynamic range is sharply reduced.
-
DRC low: The dynamic range is slightly reduced
•
Prune:
It may be that you can no longer receive some stations after a station scan or change of
location. With this function you can delete these stations from the reception list. Select
“YES” and confirm with the “ENTER / PLAY / PAUSE / CLOCK” button.
•
System
•
Language
•
Time Update
•
Factory Reset
•
SW version
Preset station:
1. Press and hold the "AMS / MODE" button on unit for about 2-3 seconds to start the
automatic preset process.
2. Display will show the memory sequence number and radio stations will be automatically
preset into the sequence number (Note: Each sequence number means 1 preset station
while during automatic preset process.)
3.
Once all the stations were automatic preset, press the “PRE. / FOLDER” button to choose
preset stations.
