ENGLISH
ENG 8
BATTERY CARE
i. If the unit is not to be used for an extended period of time, remove the battery. An old or leaking
battery can cause damage to the Remote Control.
ii. Do not dispose of batteries in fire, batteries may explode or leak.
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the Remote
Control is greatly reduced and you will need to replace the Lithium battery.
1. Remove the battery compartment from bottom of the Remote Control.
2. Install 1 “CR2025” Lithium battery with the positive side facing up.
3. Replace the battery compartment.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may damage the Remote
Control and void the warranty.
USING THE REMOTE CONTROL CORRECTLY
Note: The Remote Control is only for operating the USB and MMC Card functions.
•
Point the Remote Control at the SENSOR (IR) located on the front of the System.
•
The functions of the remote buttons are the same as the corresponding controls on the main unit.
•
The performance of the infrared SENSOR may be degraded causing unreliable operation if there
is a strong ambient light source in the same room.
•
The recommended effective distance for remote operation is about 10-15 feet.
The Stylus Replacement
Loose the red part stylus by screw driver
and take out as diagram A and B
Replace the new stylus as C and D as
diagram
The above diagram illustrates how to replace a new needle (extra needle not supplied).
SPECIFICATIONS
Power Supply:
AC 230V ~ 50Hz
Power consumption:
25W
Radio Frequency Coverage:
FM: 87.5 - 108 MHz
AM: 525 – 1620 KHz
Copyright by Woerlein GmbH, 90556 Cadolzburg,
www.woerlein.com
Changes of technical specifications without further notice
