PL910 / English Instruction Manual
4
GETTING STARTED
POWER SOURCE
This system is designed to operate on AC 100-240V~50/60Hz.
Attempting to operate from any other power source may cause
damage to the system, and such damage is not covered by
your warranty.
NOTE
:
If this plug will not fit into your outlet, you probably
have an outdated AC outlet. You should change your outlet
by a qualified licensed electrician
Adaptor AC Outlet
BATTERY INSTALLATION OF REMOTE CONTROL
The battery compartment is on the back of the remote control.
Hold and pressing the clasp with the thumb in the right
direction of arrow in the illustration, then release and remove
the battery compartment cover.
Insert two (2) AAA size batteries (not included), following the
polarity markings, into the battery compartment.
Close the battery cover into the remote control lightly until
hear a click.
Make sure the battery cover is completely locked in position.
BASIC OPERATIONS
POWER ON / OFF
Press “
STANDBY/FUNCTION
” button or “ ” button on the remote control to enter the working
mode.
Press and hold “
STANDBY/FUNCTION
” button on the unit or the
”l/ ”
button on the remote
control to turn the unit in standby mode.
SELECTING MODES
Press the “
STANDBY/FUNCTION
” button on the unit or the “
FUNCTION
” button on the remote
repeatedly to switch between modes.
ADJUSTING VOLUME
Press the
/ -
”
knobs on the unit or the remote to decrease / increase the volume.
ERP power management
If nobody presses and holds the POWER button to turn OFF the unit after stopping
playing, the unit will power off automatically after around 10 minutes. Press
“STANDBY/
FUNCTION
” button on the unit or the “l/ ” button on the remote to wake the device up
from standby mode.