PL880 / English Instruction Manual
3
GETTING STARTED
POWER SOURCE
This system is designed to operate on normal 230V 50Hz AC only.
Attempting to operate from any other power source may cause
damage to the system, and such damage is not covered by your
warranty.
NOTE
:
If this plug will not fit into your outlet, you probably have an
outdated non-polarized AC outlet. You should have your outlet
changed by a qualified licensed electrician.
Connect the speaker cable to the speaker terminal located on
the rear side of the unit. Put the red cable into the red terminal
and the black cable in the black terminal of the speaker position
(left and right).
AC Plug AC Outlet
BATTERY INSTALLATION OF REMOTE CONTROL
The battery compartment is located on the back of the remote control.
1.
Remove the battery compartment door by pressing in on the tab and
lifting it off.
2.
Insert two (2) AAA size batteries (not included) into the battery
compartment following the polarity markings inside the battery
compartment.
3.
Replace the battery compartment door.
BASIC OPERATIONS
Power ON / OFF
Press “STANDBY/MODE” button to enter the working mode.
Press and hold “STANDBY/MODE” button to turn off the unit in standby mode.
Selecting Modes
Press the “STANDBY/MODE” button on the unit or the “MODE” button on the remote repeatedly
to switch between modes.
Adjusting Volume
Rotate
the “VOL” knob on the unit or press “VOL -/+” buttons on the remote to decrease /
increase the volume.
Total 39 level volume and it displays Vol min
– Vol max.
ERP power management
If nobody presses and holds the POWER button to turn OFF the unit after stopping playing, the
unit will power off automatically after around 10 minutes. Press
“STANDBY/ MODE” button on
the unit or the
“ ” button on the remote to wake the device up from standby mode.
