SoundGate SSICRE07, Руководство по установке

Страница: 4 / 10

4
Power Wire Routing
Note: If you are installing the optional amplifi er system install the power wire for it at this time.
16. Snap loose the driver’s side front and rear threshold panel along the bottom of the door opening.
17. Snap loose the driver’s side kick panel by pulling straight back.
18. Remove the plastic cover over the power distribution center on the passenger’s side of the fi rewall near
the battery.
19. Connect the subwoofer power wire to the accessory lug. Make sure the ring terminal is oriented so that
the wire will exit the bottom of the plastic cover once it is reinstalled. Torque to 9 +/- 1.5 Nm. Fig. 9
20. If the accessory lug is not available, pull back the rubber battery lug cover on the passenger’s side
battery and attach the power wire ring terminal to the lug on the battery terminal indicated in Fig. 10
21. Route the power wire along the fi rewall to the factory
grommet on the driver’s side, secure with wire ties.
22. Using a razor knife make a cross shaped incision in the large
rubber grommet and feed the power wire from the engine
compartment to the cabin. Fig. 11
23. Install the connector on the end of the power harness inside
the cabin. The black connector should have a block out plug
installed in one side to prevent the power wire from being
inserted into the wrong position in the connector.
24. Connect the black two pin connector on the power wire to
the corresponding connector on the subwoofer harness.
NOTE: If you are installing the optional amplifi er system, it does not matter what order the three wires are
placed on the 3 pin connector, but the terminals can only be inserted one way. If the terminal will not go into
the connector simply turn it 180 degrees and try again. Push the terminals in until they click and lock into
place.