S O U N D C R A F T S I G N AT U R E M T K
R E C O R D I N G G U I D E
15
7. When you are ready to record the show, select
the master record button by the transport
control section to begin recording! You will see
waveforms starting to appear in the transport
window indicating tracks are being recorded and
audio is being written to the hard disk.
8. Once you have finished recording, simply press
the space bar on your keyboard or press the
STOP key on LOGIC’s transport section.
Multichannel playback using Logic
Once your project has been created and tracks have been recorded, you can then follow a few more steps to
playback the channels from the DAW back through the console for an analogue style mixing session.
To do this, you must assign the outputs of each channel to the corresponding USB channel of the console.
If you followed all of the above steps from the previous procedure, you will already be setup and ready for
playback through the console.
If you DID follow the steps above:
All that is required by the user is to disable the record enable icon on each DAW track, enable the USB RTN
switch on the console channels and to press play on the DAW’s transport controls.
If you did NOT follow the steps above:
You can follow the below steps to patch the DAW channels to the correct USB outputs following steps:
1. Open up the Mixer view by pressing either ‘2’ on the keyboard or via the
view tab at the top of the screen.
a. You will then be presented with the Mixer interface; All of the DAW channels are laid
out from left to right and above each channel fader and pan control there are 2 dialogue
boxes that contain the input and output patch of each channel.
2. Click and Hold the bottom of the two I/O boxes to open up the output selection pop up.
3. Scroll down to outputs, mono and select output 1
(Or the first ‘part of stereo ‘dialogue).
4. Then assign the next tracks output to be mono
output 2. Repeat across all recorded channel
either to assign the Daw outputs to the mixers
USB interface.
5. Once all of the tracks have been patched to their
respective outputs, you then need to disable
record enable on each input tracks and then press
play on Logic’s transport bar.
