Soundcraft 328XD and Alesis ADAT and BRC
6
66
6
BRC AND ADAT CONFIGURATION
Firstly, turn on the
Client
ADAT. Allow a few seconds for the ADAT to boot correctly. Next turn on the
Master ADAT. Allow a few more seconds for the ADAT to boot and recognize the
Client
ADAT. Then turn
on the BRC. Ensure that the BRC recognizes both ADATs. If it does not recognize the ADATs, you will
need to turn off the BRC and reinitialize it, by holding down <RECORD> and <PLAY> and turning on the
BRC. You may need to repeat this procedure until the BRC recognizes the two ADATs.
Once the BRC and ADATs are stable, the BRC must be set up correctly.
BRC Setup
TIMECODE
To set the BRC to Timecode generation to either MTC or SMPTE:
MTC:
Press <EDIT>, <GEN SYNC>, <GEN SYNC> on the BRC. Using the <UPPERCASE> and
<LOWERCASE> cursor keys, select MTC.
SMPTE: Press <EDIT>, <GEN SYNC> on the BRC to select SMPTE timecode output. Using the
<UPPERCASE> cursor key 4dB.
NOTE:
SMPTE should only be selected if the SMPTE cable is connected between the BRC and the
328XD.
WORDCLOCK
Press <EXT SYNC> on the BRC. Ensure that the <EDIT> button has remained lit, and use the
<UPPERCASE> and <LOWERCASE> cursor keys until the display reads
To leave the EDIT mode, press <EDIT>
