SoundBrick
®
550N
11/2007
20
QUICK INSTALL INSTRUCTIONS
12VDC power supply
(included)
⎝
Connect to phone system’s
For more detailed instructions, read the inside of the manual.
1. Consult message length table (page 9) and tape preparation info. (page 8) if
needed. Set option (DIP) switches:
--Night message size, switch 1 (off = 30 sec., on = 60 sec.)
--Bandwidth, switch 2 (off = 6.5KHz, on = 11.5KHz)
--Password
select,
switches 3-4 (see table on page 11)
--Night answer rings, switches 5-6 (see table on page 10)
--Night answer on/off, switch 9 (off = night answer off, on = night answer on)
--Speaker on/off, switch 4 (off = speaker off, on = speaker on)
Note: A switch is on when it is pointing towards the switch numbers and
off when it is pointing away from the switch numbers.
2. Connect the power supply and phone system MOH port as shown above.
Connect night answer phone line and optional trigger cable, if applicable.
3. Turn the power switch on. To load by tape, press the eject button on front of the
SoundBrick to open the motorized tape drawer. Insert the cassette into the tape
drawer by gently sliding it underneath the retaining clip, audio side facing front,
then press the eject button, or momentarily push the drawer to close. After an
initial scan of the tape, loading begins automatically. To load messages by
phone, see page 14.
MOH port
⎝
Connect to timer or trigger
hardware
mono RCA cable (included)
RJ-11 telco cable (included)
⎝
Connect to phone line
1/8” mini-plug trigger cable (optional)
