Sound Skulptor SK99 Скачать руководство пользователя

Страница: 3 / 4

www.soundskulptor.com

Document revision 1.1 – Last modification : 10/08/17

SK99 Assembly guide

8. Inductor

Add L1 (red).
Bend sharply one of the leads against the body of L1 for a vertical
insertion.

9. Resistors

Bend sharply one of the leads against the body the resistor for a vertical
insertion.
Add R1 to R13.

Warning

: It is very important to check the resistors value with a DMM

because the colour code can be ambiguous. For example 1K (brown-black-

black-brown-brown) can be confused with 110R (brown-brown-black-black-
brown).

10. Capacitors

Add C1 and C2.

11. Q9 & Q10 assembly

Attach Q9 (BD139) to the heatsink PCB marked “Sound Skulptor” with
a M3x12 mm screw and a M3x20 mm spacer. The transistor is placed
on the side with no writing.

Tighten softly, by hand for now.

Содержание SK99

Страница 1: ...e connection between the top and bottom pads is already done The parts must be soldered only from the bottom side unless differently stated Use only small diameter solder 0 5 or 0 7 mm 1mm maximum Use the minimum possible amount of solder Bad joints are almost always caused by too much solder Here are two excellent introduction to soldering videos http www eevblog com 2011 06 19 eevblog 180 solder...

Страница 2: ...ed vertically cathode black ring up Add D1 D2 D7 D8 D9 1N4148 blue on the picture Add D4 zener 5 1V green on the picture Warning Make sure to respect the direction of the diodes D7 D8 D9 are mis labeled on the PCB follow the layout document 6 LED Add the red LED D3 red on the picture Warning Make sure to respect the long lead short lead direction of the diode 7 Transistors Add Q1 BC560C purple Add...

Страница 3: ... R1 to R13 Warning It is very important to check the resistors value with a DMM because the colour code can be ambiguous For example 1K brown black black brown brown can be confused with 110R brown brown black black brown 10 Capacitors Add C1 and C2 11 Q9 Q10 assembly Attach Q9 BD139 to the heatsink PCB marked Sound Skulptor with a M3x12 mm screw and a M3x20 mm spacer The transistor is placed on t...

Страница 4: ...he main PCB edge then solder the transistor pins Cut the leads sharp Keeping the DOA pressed against the table tighten the 2 screws with a screwdriver 14 Q9 Q10 assembly Solder the 4 pads at the bottom of both heatsinks that connect to the main PCB These solders improve the mechanical stiffness of the DOA and make the electrical connection of diodes D5 D6 15 R1 Pull R1 back a little in order to av...

Результаты поиска

Содержание SK99

Отзывы:

Похожие инструкции для SK99

Бренды по названию

Популярные бренды

Sound Skulptor SK99, Инструкция по сборке

Результаты поиска

Содержание SK99

Отзывы:

Похожие инструкции для SK99

Бренды по названию

Популярные бренды