Sound Magus H500, Руководство пользователя

Страница: 4 / 12

AMPLIFIER FUNCTIONS
1 2
3
4
1
Speaker connection
2 +12V Battery Terminal
3
Remote ON/OFF input
4
Ground Terminal
6
RCA audio-input
This knob adjust the high-pass frequency for 4x full frequency channels. The high-
pass filter will turn off at the most counterclockwise position, the cutoff frequency will
increase when knob turning clockwise till 200Hz.
Gain control regulates the sensitivity of amplifier to match the signal output voltage
of your source unit
.
The gain control is not a volume adjustment
.
Use high quality
CD music and increase the volume of your source unit to 75
%.
Position the gain at
the minimum and then increase gain slowly
(
clockwise
).
Stop at the first sign of
distortion
,
then lower the gain a little
(
counter clockwise
)
to achieve clear
undistorted music at the maximum level
.
7 High-Pass-Filter for 4x full frequency channels
Connect your speakers correctly which means plus to plus and minus to minus
.
Never connect speaker cables with chassis ground directly
.
It may destroy your
amplifier
.
We recommend AWG 16
#
speaker cable
.
The detailed connection ways
are shown in page 7
-
8
.
The
+
12 Volt power cable must be connected with a fuse in line near the battery
+
terminal
.
Please use Gauge 4(or up) power cable and 80A in-line fuse.
Remote control terminal
.
The remote control cable must be connected with source
unit remote terminal so the amplifier will switch on and off automatically with
source unit
.
If there are two or more amplifiers connected to this terminal it might
be necessary to add an additional relay
.
Chassis ground terminal
.
The chassis ground cable must be connected very tight
on a nearby massive and electric conductive place. Please connect chassis ground
near amplifier with same gauge as power cable
.
5
Gain
These RCA audio
-
inputs connect with your source unit RCA outputs
.
Please use
car audio RCA cables
,
otherwise it may be disturbed
.
Keep these cables as short
as possible
.
To avoid disturbances from your car electronics
,
please don
'
t close
the existing car cables when you install the RCA cables
.
If your source unit has
only one group output
,
please use a suitable Y
-
RCA adaptor
.
If your source unit
has only speaker outputs
,
you should use a HIGH
-
LOW level adaptor
.
OFF
5 5
5 5 5 5
6
7
9 8
1 0
1 1 1 2
3
4