SL-2
User Guide
7
STEP 5
Position the SL-2 Rear Bracket on the rear panel of the
SL-2 as shown in the image below.
Secure the SL-2 Rear Bracket
with two 6 mm screws using the supplied 2 mm Allen Wrench.
STEP 6
Align the SL-2 Rear Bracket and the Rear Keyhole Peg on
the Scorpio. The SL-2 should be tilted with the front panel slightly
higher than the rear. Take care not to bump the SL-2 Expansion
Connector against the Scorpio top panel. Lower the rear of the
SL-2 Rear Bracket onto the Rear Keyhole Peg on the Scorpio.
Once the SL-2 Rear Bracket and Rear Keyhole Peg’s machined
grooves are aligned, slide the SL-2 towards the front panel.
STEP 7
Make sure that the SL-2 Expansion Connector
mates with the Scorpio Expansion Port. Then gently press
down on the SL-2 to fully seat the pins of the connector.
\
STEP 8
Secure the SL-2 to the Scorpio Front Bracket
with
two 6 mm screws using the supplied 2 mm Allen Wrench.
STEP 9
Secure the SL-2 to the Scorpio with two 6 mm screws
on either side of the Expansion Connector as shown in the
image below using the supplied 2 mm Allen Wrench.
