© 2008-2022 SOTA Instruments Inc.
Page 4 of 7
|
www.sota.com
The Water O
3
zonator Model WOZ5 Manual
b. it is important to place the water with submerged airstone in a well-ventilated
area, as concentrated ozone in air may irritate lung tissue. for example, under a
stove-top fan. Place the container of ozonating water well away from the ozone
unit.
note: ozonating liquids other than water may clog the airstone and will void the
warranty.
4.
Push the ON/OFF/TIMER button to turn the unit ON. All the lights will flash in
sequence to indicate the unit is ready for use.
a. the unit starts with the 5 minute timer cycle.
b. if more than 5 minutes is required, push the
on/off/timer button—each push moves the
timer from 15, to 30, to 60 minutes. A green
flashing light indicates which time is set. See
page 6 for timing.
5.
Check to be sure fine bubbles pass out of the
Airstone into the water. if you do not see any
bubbles, ensure the silicone tubing is firmly
attached to the ozone outlet on the side of the unit.
As the unit operates, you should catch the smell of
ozone.
6. At the end of a timed session, the unit will beep,
all the LED lights will flash, and the air pump will
continue to operate for an additional 10 seconds to
purge the ozone from the tube. the unit will then turn itself off.
Allow water to drain from the tubing after use. this ensures water will not drain
back into the unit.
7. Use the freshly ozonated water
immediately
for optimal results. if left for 20 minutes
in open air, the ozone dissipates out of the water and the benefits of the extra oxygen
will no longer be present.
8. to turn the unit off at any time, hold the on/off/timer button down for a full
two seconds.
9. turn the unit off and
unplug the wall adaptor
when not in use.
