S
urvival
O
perations
S
pecialist
SOLAS (74/96) Approved Lifejacket
SOS MARINE
A.B.N 48 000 803 841
23A Rochester St Botany NSW Australia 2019
Ph: +61-02 9700 0233 Fax: +61-02 9700 0277
WWW.SOSMARINE.COM
Page
10
of
16
1.7.10 Replace gas cylinder-screw-up until tight.
1.7.11 Replace oral inflation cap.
1.8 WEBBING HARNESS AND FITTINGS.
Visual inspections before use:
1.8.1 Inspect all webbing and components and attachment points for wear
deterioration or contamination by oil’s lubricants or other contaminating
substances that may cause damage, check all metal fittings for signs of
damage cracking, distortion and corrosion.
NOTE:
If any doubt regarding the serviceability, it should be returned to
SOS Marine or its agent for assessment and or replaced.
1.8.2
WARNING
: The deck safety harness is suitable for an adult wearer of
50 kg or more.
1.8.3
WARNING
: The deck safety harness and safety line are intended to
prevent the user falling overboard. They do not provide protection against
falls from height.
1.8.4
WARNING
: The deck safety harness and safety line may transmit very
large forces. Only attach to strong Hooking Points or Jack-lines.
1.8.5
WARNING:
Unless the deck safety harness is supplied with Automatic
Tension, it is unsafe to wear this harness loose, the harness shall be
worn tightly in order to be effective.”
1.8.6
WARNING:
Use of a sailing harness to prevent falls overboard presents
several risks, in case of capsizing or sinking, the boat may take you down
as such, ensure that any tether used has quick release under load
hardware, this harness has not been designed for all arrest, lifting or
climbing and should not be relied upon in any of these instances.
1.9
TECHNICAL DATA (Bladder Assembly)
1.9.1 Personal Application:
Fits adult body weight of 50kg or more with a Chest 76-132cm
1.9.2 LEVEL 275: Made to comply: ISO 12402-2
For Offshore, extreme conditions, special protective clothing heavy equipment.
1.9.3 Harness and Safety line and webbing D Ring attachment the following products
conforming to ISO I240I: 2009.
1.9.4 Quick Burst Zipper meets all relevant requirements of: ISO 12402-7.
