Page 15/17
Assembly Instructions
MINI Control
www.sorotec.de
V 1.0.0
LED Module
Fig. 31: Status LEDs show the operating status
The optional LED module is used for optical signaling
of various switching states, such as emergency stop
or spindle ON. The meanings of the individual LEDs
are already marked on the sticker on the front.
• Open the holes for the LED module covered
with the sticker with a sharp knife.
• Plug one end of the connection cable into the
red socket on the module circuit board.
• Fasten the LED module with the enclosed
screws. Fig. 32.
• Plug the other end of the connection cable into
the red socket on the main circuit board as
shown in Fig. 33.
Attention!
Be sure to attach the ribbon cable to the adhesive
sockets with cable ties! A cable that is supplied loose
can easily be damaged by one of the screws faste-
ning the housing cover. Risk of short circuit!
Fig. 32: Built-in LED module from inside
Fig. 33: Connector on the motherboard
Note
The plugs of the ribbon cables are secured with
a side lug to prevent them from being plugged in
accidentally. Don‘t force it in!
Fig. 34: Screw can puncture unfastened cables.