Installation
20
Ultrasonic Generator | DocNr.: 03-4655 R03.01 | 22.09.2015 | en-US
Connecting the foot switch
Requirements
The actual power voltage corresponds to the output voltage shown on the serial
plate.
The ultrasonic generator is turned off; the power switch is set to '0'.
Procedure
1. Connect the power cord to the connector socket on the back of the ultrasonic
generator.
2. Connect the power cord to the main power supply.
3. Connect a potential equalization cable to the connection on the back of the ultra-
sonic generator if required.
4. If necessary, connect the potential equalization cable to the potential equaliza-
tion rail in the room.
– The ultrasonic generator is connected to the main power supply.
5.2 Connecting the foot switch
A single foot switch must be connected to the ultrasonic generator.
Procedure
1. Connect the cable on the foot switch to the connector socket on the front of the
ultrasonic generator.
– The foot switch cable engages in the connector socket.
– The foot switch is connected.
out.fm Seite 20 Dienstag, 22. September 2015 3:24 15
