18 of 28
Service Record Mio Carbon (Design 2018)
2020-09-01
3.6.2 Bowden cable brake
3.6 Assembly group brake
The bowden cable brake is embedded in the
clothing protection side part and is operated
via a bowden cable brake. This must be re-
gularly checked for proper functioning and, if
necessary, tightened.
• (1)
The re-tensioning of the bowden
cable unit (Bowden cable) is carried
out by turning the adjusting screw
(A)
:
clockwise = tension, against UZS =
release.
• (2)
For changing the distance between
the brake pressure pin and the rear
wheel
• If necessary, loosen both screws
(C)
on
both sides
• with the brake open, move the entire
brake body to the new position,
• Tighten screws again.
Afterwards, check the functionality of
the brake.
(1)
(A)
(C)
(2)
(4)
To adjust the length of the brake lever:
• loosen both screws
(A)
on both sides if
necessary,
• align brake lever
(B)
,
• retighten all screws
(A)
.
Afterwards absolutely check the func-
tionality of the brakes! The wheelchair with
occupant (maximum load) must stand secu-
rely with the brakes applied on a ramp with a
gradient of 12% (= 7 °).
3.6.3 Adjust length brake lever
(A)
(B)
(4)
