(2) Using the remote control
2.1
Power button.
(1) In standby or countdown mode: Press the power button to start the machine.
Note: The default speed is 0.5km/h.
(2) Choosing the preset programme: Press the power button to start the machine –
the speed will change according to the preset speed.
(3) In its running state: Pressing the power button will slowly stop the treadmill – it
will go back to standby.
2.2 ‘+’ and ‘-‘ adjusts the speed. Keep pressing ‘+ / -‘ over 0.5 seconds, the speed
will keep increasing or decreasing by 0.1km.
2.3 M:
①
In standby: It can switch between modes, including time, distance and
Calories.
②
In its running state: Pressing ‘M’ will switch the display mode
between cyclic and single display mode.
2.4 P: The preset programmes range between P01-P12 – they can be chosen when
the machine is in standby.
2.5 Press
once to mute the machine – press again to resume the ‘beeping’
sound.
2.6 After use, press
to slowly stop the treadmill – it will retain its data until
powered off. It will resume the previous speed when turned back on.
Reset: Press
to reset the data. This will only work in standby.
(3) Functional Instructions
3.1 Sports mode: Press the ‘start’ key to begin – the SPEED display will count down from
‘3, 2, 1’. Machine starts in P00 mode and starts counting from 0:00 to 99:59 minutes.
The number will reset to 0:00 when it reaches the maximum number. Note: The
default speed is 0.5km/h. Press + or - to adjust the speed.
3.2 Countdown mode: when in standby, press ‘M’ to set a timer (5:00-99:00 minutes. The
default is 30:00), distance (1-99 mi. The default is 1.0 mi) and calories (20-9990 kcal.
The default is 50 kcal). Press + or - to select a desired number. After setting, press
the power button to start the treadmill, it will count down from the set number. The
-5-
