1. CEA-2006 Compliant — Standardized “Voluntary” Testing & Measurement Methods for
Mobile Audio Amplifiers. This standard advocates a uniform method for determining an
amplifier’s RMS power and signal-to-noise ratio. Using 14.4 volts, RMS watts are measured
into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a
frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz.
© 2009 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without
written permission is prohibited. Sony, Memory Stick, nav-u, Quick-BrowZer, Walkman,
Xplod, ZAPPIN, and the Sony, nav-u and Xplod logos are trademarks of Sony. iPhone and
iPod are trademarks of Apple Inc., registered in the U.S. and other countries. Bluetooth is
a trademark of Bluetooth SIG, Inc. NAVTEQ Maps & Traffic is a trademark of NAVTEQ. All
other trademarks are trademarks of their respective owners. Features and specifications
are subject to change without notice. Non-metric weights and measures are approximate.
/Updated: December 14, 2011
Inputs and Outputs
Audio In
RCA Pin Jacks, High Level Input Connector
Audio Out
Speaker Terminals
Input(s)
RCA Pin Jacks and High Level Speaker Input Connector
Line Level Input(s)
RCA pin jacks
Output(s)
Speaker Terminals
RCA Audio Input(s)
Pin Jacks: 0.3 - 6V
Power
Current Drain
At rated output:45A (at 4 Ohms)
Remote Input: 1 mA
Input Voltage
10.5-16V Power Supply Voltage
Internal Power Supply
OTL Output Transformerless Circuit
Pulse Power Supply
Output Power
Maximum Output: 380Wx2 (at 4 Ohm)
1000W x 1 (at 4 Ohms)
Power Requirements
12V DC Car Battery (Negative Ground)
Rated Output
185W x 2 (20Hz-20kHz, 1% THD+N, 4 Ohms, 14.4V)
1
200W x 2 (20Hz-20kHz, 1% THD+N, 2 Ohms, 14.4V)
400W x 1 RMS (20Hz-20kHZ 1.0% THD+N, at 4 Ohms)
Speaker
Impedance
2-8 Ohms in Stereo Mode, 4-8 Ohms in Stereo Mode
Speaker Terminal Type
Output
Weights and Measurements
Dimensions (Approx.)
15 3/4 x 2 1/4 x 11 3/8"
(400 x 55 x 288 mm)
Dimensions (Approx) Depth
11 3/8"
Dimensions (Approx) Height
2 1/4"
Dimensions (Approx) Width
15 3/4"
Weight (Approx.)
7 lbs. 15 oz.
Supplied Accessories
Supplied Accessories
Mounting Screws (4)
High Level Input Cord (1)
Protection Cap (1)
