106
Setup Menu
Chapt
er
7
Men
u
s
a) Not displayed when the unit is in 23.98P mode.
b) In 1-in/1-out mode, adjusts the PB level. In VTR mode, adjusts the PB/EE level.
743
PR LEVEL (HD)
b)
Adjust the PR level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–2048 to 0 to 846
745
SETUP LEVEL (HD)
b)
Adjust the setup level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–272 to 0 to 272
746
SYNC PHASE (HD)
Control the H sync phase of the high-definition video signal output from
the HD-SDI OUTPUT or HDMI OUTPUT connectors.
–128 to 0 to 127
747
FINE (HD)
Fine control the H sync phase of the high-definition video signal output
from the HD-SDI OUTPUT or HDMI OUTPUT connectors.
0 to 1023
Menu items in the 700s, relating to video control
Item number
Item name
Settings
Menu items in the 800s, relating to audio control
Item number
Item name
Settings
802
DIGITAL AUDIO MUTING IN
SHUTTLE MODE
Set the audio muting conditions during shuttle playback.
off
: Not muted.
on
: Muted.
807
AUDIO OUTPUT PHASE
Set the output timing of digital audio playback signals (HD-SDI, SDI,
AES/EBU only) as a hexadecimal value, with 80 as a reference position.
Output timing is earlier for values smaller than 80 and later for values
greater than 80. (80, 128 samples = approx. 2.7 ms, 80, 1 sample =
approx. 20
μ
s)
0 to 80 to FF:
Values can be set in this range.
808
INTERNAL AUDIO SIGNAL
GENERATOR
Select the operation of the internal audio test signal generator.
off:
Do not output test signal.
silence [silnc]
: Silent signal
1kHz sine [1kHz]
: 1 kHz, –20 dB FS sine wave signal
When you set the INT SG item on page P1 INPUT of the function menu
to “ON”, the internal signal generator operates and outputs simultaneous
test signals to channels 1 to 8
.
815
AUDIO SAMPLING RATE
CONVERTER
Select the mode of operation of the sampling rate converter for AES/
EBU input to channels 1 to 8.
off
: Do not operate.
on
: Operate.
823
NON-AUDIO FLAG PB
Control non-audio flags in digital audio output.
Sub-item
1
CH1/CH2
During playback (except in E-E mode), set non-audio flags in digital
audio output to the following states.
on:
Set to on (data is non-audio.)
auto:
Set as follows.
• When data is read from media and confirmed: Follow the data.
• When data from media is not confirmed: Maintain current state.
2
CH3/CH4
3
CH5/CH6
4
CH7/CH8
824
ANALOG LINE OUTPUT SELECT
Select the analog audio signals (tracks 1 to 8) to be assigned to audio
output channels 1 and 2.
tr1/2
: Tracks 1 and 2 assigned to audio output channels 1 and 2.
tr3/4
: Tracks 3 and 4 assigned to audio output channels 1 and 2.
tr5/6
: Tracks 5 and 6 assigned to audio output channels 1 and 2.
tr7/8
: Tracks 7 and 8 assigned to audio output channels 1 and 2.
