Sony XDCA-53, Руководство по эксплуатации

Страница: 11 / 20

11 Names and Functions of Parts
n
INTERCOM LEVEL knob
Adjusts the receiving volume level of the
headset connected to the INTERCOM
connector.
o
INTERCOM MIC switch
Controls the headset microphone connected
to the INTERCOM connector, turning it on
or off as required.
ON: Turns the headset microphone on.
OFF: Turns the headset microphone off.
PTT: Turns the headset microphone on for
as long as the switch is held in this
position.
p
TALLY lamp (green)
When the TALLY switch is on, lights in
green when a green tally signal is input to
an XDCU-50 connected to the adaptor.
q
TALLY lamp (red)
When the TALLY switch is on, lights in red
when a red tally signal is input to an
XDCU-50 connected to the adaptor, and
when a call signal is received, for example
because a CALL button was pressed on
another device.
This lamp does not light when the adaptor’s
CALL button is pressed. It does not light
either when the CALL button on the remote
control unit or other device is pressed.
r
DC OUT 12V(2A) connector (4-pin
round)
Connect to the DC IN connector of the
camcorder with the supplied power cable.
s
REMOTE connector (8-pin)
Connect to the REMOTE connector of the
camcorder with the supplied REMOTE
cable.
t
GENLOCK OUT connector
Connect to the GENLOCK IN connector of
the camcorder with the supplied BNC
cable. Reference sync signals output from
the XDCU-50 are sent as SD black burst
signals to the camcorder via this connector.
u
MONITOR OUT connector
Outputs SD analog composite video
signals, either return video signals from
XDCU-50 or the camcorder video signals.
v
SDI IN connector
Connect to the SDI OUT connector of the
camcorder with the supplied BNC cable.
SDI signals output from the camcorder are
input to this connector.
w
Accessory screw holes
These are accessory screw holes (4) for M4
screws to secure an HD monitor.
x
Accessory screw holes
These are a screw hole for an U1/4-20
screw to secure an accessory, and eight
screw holes to secure the accessory kit.
y
Camera adaptor mounting screw
holes
These are screws holes for M4 screws,
allowing you to secure the adaptor to the
optional VCT-SP2BP Camcorder Support.
Note