Page 4 sur 6
5) CAUTION – RISK OF ELECTRIC SHOCK. Remember to work with mains power disconnected. Connect the Power
supply cable and the network cables as described in the section
4. Connection & cabling
Connection & Cabling
1) The 3 cable glands (supplied) must be used to ensure housing integrity and compliance to IP66.
2) CAUTION: SWITCH OFF THE 220 VAC POWER LINE
3) Pass the power cable through the cable gland
4) Plug and screw the power cable (NEUTRAL, LIVE and EARTH) as below :
N+
NEUTRAL (Blue cable)
L-
LIVE (Brown cable)
GND
EARTH (Green/Yellow cable)
5) Plug the Network cable (CAT5) as shown below, to setup the camera:
6) Plug the Network cable (CAT5) to your laptop. In case of direct connection from the camera to the laptop, use a cross cable.
NB: No need to pass the network cable through the cable gland if the network is only used to setup the camera.
7) Select either Wiegand or RS232 on the
Wiegand Converter
as below:
Wiegand channel
Plug jumpers as above
RS232 channel
Plug jumpers as above
5
N+
L-
GND
Electronic Bridge & Heater Control
2
N+
L-
GND
IN
1.
Ethernet input
1
