Page 2 sur 6
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE
DURING INSTALLATION.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN ANY INTERNAL DEVICE AND CABINET INSIDE THE HOUSING OF THE
CAMERA. REFER SERVICICE TO QUALIFIED PERSONNEL ONLY.
CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE
THE EQUIPMENT.
CAUTION: USE THE POWER SOURCE DESCRIBED IN THIS MANUAL.
CAUTION: FOR SAFETY REASONS DO NOT CONNECT THE CONNECTOR FOR
PERIPHERAL DEVICE WIRING THAT MIGHT HAVE EXCESSIVE VOLTAGE TO THIS PORT.
FOLLOW THE INSTRUCTIONS FOR THIS PORT.
This mark applies in EU
countries only
WARNING
.
This unit has no power switch.
When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power cord to socket-
outlet which must be provided near the unit and easily accessible.
If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the
power cord.
CE COMPLIANCE STATEMENT
WARNING: THIS IS A CLASS A PRODUCT. IN A DOMESTIC ENVIRONMENT THIS PRODUCT MAY CAUSE RADIO
INTERFERENCE IN WHICH CASE THE USER MAY BE REQUIRED TO TAKE ADEQUATE MEASURES.
CAUTION: BEFORE ATTEMPTING TO CONNECT OR OPERATE THIS PRODUCT, PLEASE READ THE LABEL ON THE
BOTTOM AND USER'S MANUAL CAREFULLY.
CAUTION FOR LAN PORT: FOR SAFETY REASON, DO NOT CONNECT THE LAN PORT TO ANY NETWORK DEVICES THAT
MIGHT HAVE EXCESSIVE VOLTAGE.
CAUTION: DURING THE PRODUCT INSTALLATION, A DEVICE OUTAGE MUST BE USED.
CAUTION: FUSE ON THE ELECTRICAL INSTALLATION MUST BE 16A OR LESS.
CAUTION: AN OVERCURRENT PROTECTION DEVICE SHOULD BE USED TO AVOID DAMAGE RISK FOR THE PRODUCT.
CONTENTS
Highlights................................................... 3
Unpacking.................................................. 3
Installation.................................................. 3
Connection & cabling................................. 4
Specifications............................................. 6
Safety Instructions
- Refer all work related to the installation of this product to qualified service personnel or system installers.
-
Do not attempt to disassemble the camera. There are no user serviceable parts inside. Contact qualified service
personnel for maintenance.
-
Handle the camera with care. Do not strike or shake, as this may cause permanent damage. It should be
protected against extreme pressure, vibration and humidity during transportation and storage. Damages caused
by improper transportation void the warranty.
- During product setup, do not expose the product to water or moisture, and do not try to operate it in wet areas.
Take immediate action when the product becomes wet. Turn off the power and refer servicing to qualified service
personnel. Moisture may damage the device and cause electric shock.
- Do not shoot images that are extremely bright (e.g. light sources, the sun, etc.) or long periods of time
-
Use an appropriate power supply. Do not apply excessive voltage, use only specified voltages. Otherwise, you
may get an electrical shock or a fire may occur.
-
Connect the unit to a power supply corresponding to the one indicated on the rating.
-
The outlet must be adequately earthed according to the regulation in force.
-
Before moving or carrying out technical operations on the unit, isolate and disconnect it from the power supply.
- Do not use worn or damaged power cords, since they represent a serious risk for the user’s safety.
- The installation of the unit must be carried out by adequately skilled technical personnel.
- Do use the device in areas containing inflammable substances.
- Make sure that the unit is mounted securely using fixings adequate for the weight and the mounting surface.
- The unit is considered switched off only when the power supply is isolated and the connecting cables to the unit
are disconnected from the supply.
- Keep this manual safe for future reference.
