10
GB
Cautions
• Do not install this unit in a car that has no ACC
position. The display of the unit does not turn off
even after turning the ignition off, and this causes
battery drain.
• Run all ground (earth) leads to a common
ground (earth) point.
• Do not get the leads trapped under a screw or
caught in moving parts (e.g., seat railing).
• Before making connections, turn the car ignition
off to avoid short circuits.
• Connect the power supply leads
to the unit and
speakers before connecting it to the auxiliary
power connector.
• Be sure to insulate any loose unconnected leads
with electrical tape for safety.
• Choose the installation location carefully so that
the unit will not interfere with normal driving
operations.
• Avoid installing the unit in areas subject to dust,
dirt, excessive vibration, or high temperature, such
as in direct sunlight or near heater ducts.
• Use only the supplied mounting hardware for a
safe and secure installation.
• Be sure to use the supplied USB extension cables.
• This unit may not be installed properly depending
on the car type. For details on the mounting
space, see “Ensuring the mounting location of the
unit” (page 10).
• To avoid injury, be careful not to drop the display
during installation.
• When installing, be careful not to cut off your
fingers with the metal parts of the brackets and
mounting base.
• Do not pinch your fingers when attaching the
display to the unit.
• Do not install the unit in a position where the unit
interferes with driving operations (such as in
positions where the shift lever hits the unit, or the
hazard button cannot be pressed).
• When using the unit for a long period of time,
there may be a possibility that the screws securing
the display may come loose. Periodically tighten
these screws.
• Do not make any changes or modifications to the
unit other than those described in this manual.
Note on the power supply lead (yellow)
When connecting this unit in combination with other stereo
components, the amperage rating of the car circuit to which
the unit is connected must be higher than the sum of each
component’s fuse amperage rating.
Note on installing in cars with a start-stop system
The unit may restart when starting the engine from start-
stop. In this case, turn off the start-stop system of your car.
Note on installing in cars with electric parking brake
system
For cars with electric parking brakes, some related functions
(such as video blocking function) may not work properly.
Mounting angle adjustment
Adjust the mounting angle to less than 30°.
• Make sure that the distance from the front surface
(reference surface) of the mounted unit to the
surface of your car's center cluster is within 22 mm
(
7
/
8
in). If exceeded, the unit cannot be installed
properly.
• For your safety, adjust the mounting location of
the unit so that it does not interfere with driving
operations such as button (switch) or shift lever
operations.
Connection/Installation
Ensuring the mounting location of the
unit
Before installing the unit, consult the installer for
details on the installation of the unit and the
display.
ɸ
ɹ
Front surface of the unit
(reference surface)
Center cluster panel of
your car
Screw hole positions
(for securing the display and the unit)
22 mm (
7
/
8
in)
51 mm to 71 mm (2
1
/
8
in to 2
7
/
8
in)
ɻ
ɼ
ɺ
ɻ
Hidden area even when the display is
slid up or down
Position of the unit (reference position)
60 mm (2
3
/
8
in)
76 mm (3 in)
60 mm (2
3
/
8
in)
