17
GB
3
At the desired position, tighten the 3 screws
firmly to secure the connector bracket.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be less than
1.5 N•m).
Adjusting the height of the display
position
1
Remove the 4 pre-installed screws for
height adjustment (on both sides).
2
Slide the connector bracket up or down to
decide the appropriate height position.
Adjustable height: within 60 mm (2
3
/
8
in) (
),
in 7 steps, in 10 mm (
13
/
32
in) pitch (
).
3
At the desired position, tighten the 4 screws
firmly to secure the connector bracket.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be less than
1.5 N•m).
Adjusting the display angle (tilt)
1
Remove the 2 pre-installed screws for angle
adjustment (on both sides).
2
Adjust the display angle to decide the
appropriate angle.
Adjustable angle: -10° to +10°, in 3 steps
Screw holes to use:
3
At the desired angle, tighten the 2 screws
through the screw holes (upper or lower)
that match the display angle.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be less than
1.5 N•m).
Pre-installed screws
ɹ
ɸ
ɹ
ɹ
ɹ
Pre-installed screws
0° (1 – A)
-10° (3 – B)
+10° (2 – B)
