Sony WEGA KLV-23HR1, Руководство по эксплуатации

Страница: 12 / 56

12
Installing and Connecting the TV
Connecting a VCR and Cable TV
Use this hookup if:
• You have Cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR’s IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Note
To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the
(Setup) menu (See below).
Tips
• You can also use the VIDEO 2 IN jacks on the front panel of the TV to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN)
separately. The TV is factory set to receive S VIDEO input signals.
1
Press TV/VIDEO repeatedly until the desired video input appears.
2
Press MENU.
3
Press
V
/
v
to select (Setup), then press .
4
Press
V
/
v
to select “Auto YC,” then press .
5
To watch the pictures input from the S VIDEO input jack:
Press
V
/
v
to select “On,” then press .
To watch the pictures input from the VIDEO input jack:
Press
V
/
v
to select “Off,” then press .
6
Press MENU to exit the menu screen.
VHF/UHF R-AUDIO-L VIDEO S VIDEO
VIDEO 1 IN AUDIO OUT
R L DC IN 14.5V R-AUDIO-L
VIDEO 3 IN
Y P
B
P
R
YC-15V/30V (not supplied)
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
VMC-810S/820S
(not supplied)
VCR
Cable
S VIDEO
Rear of TV
75-ohm
coaxial cable
(supplied)
75-ohm
coaxial
cable
(supplied)