Sony VPLVW40 - SXRD Projector - HD 1080p, Руководство по эксплуатации

Страница: 53 / 80

53
Others
On-screen display
Remote control
The color gradation of the
dark area or the bright area
of the picture from the
HDMI 1 or HDMI 2
connector becomes
unclear. c The color gradation of the dark area or the bright area may
become unclear when a signal other than those from HDMI
standard is input. Adjust the “Brightness” and the “Contrast” in
the Picture
menu. ( 1 page 41)
The picture is too dark. c Adjust the “Contrast” or “Brightness” of the Picture menu
properly. (
1
page 41)
The picture is not clear. c Adjust the focus. ( 1 page 24)
c
Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
The picture flickers.
c
Activate “APA”, then adjust the current input signal.
c Adjust “Phase” for “Adjust Signal” in the Screen menu
properly. ( 1 page 45)
Symptom Cause and Remedy
Symptom Cause and Remedy
On-screen display does not
appear. c Set “Status” in the Setup menu to “On.” ( 1 page 46)
c
Check if the
?
/
1
(ON/STANDBY) indicator should light in
green.
The model name does not
disappear from the screen.
c
The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Symptom Cause and Remedy
The remote control does
not work. c Batteries could be weak. Replace them with new batteries.
(
1
page 11)
c Insert the batteries with the correct polarities. ( 1 page 11)
c In the Installation menu, set the setting of “IR Receiver” to
“Front & Rear”. ( 1 page 49)
c
If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently. Change the
setting of “IR Receiver” in the Installation
menu. ( 1 page 49)