32
The Connection/Power Menu
*1:
To set the IP address manually, select “Manual”, press “Apply”, then enter the IP address.
*2:
Reflecting changes in WLAN settings may take a few moments.
*3:
If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see “Setting the WLAN Network of the projector”
(page 41).
*4:
The factory default settings for “Access Pt. (Manual)” are as follows.
SSID: VPL + MAC address for LAN
Security Method: WEP(64bit)
Wireless Password: sony1
To change the settings for “Access Pt. (Manual)”, use a Web browser.
For details, see “Setting the WLAN Network of the projector” (page 41).
*5:
For changing the settings for “Client,” use the Web browser for change. For details, see
“Setting the WLAN Network of the projector” (page 41).
*6:
VPL-CH375/CH355 only.
*7:
If the image input setting of the HDMI connection equipment is not correct, the brighter part
becomes too bright and the darker part becomes too dark.
*8:
The INPUT D terminal is available on VPL-CH375/CH355 only.
*9:
This may not be optimum depending on the input signal. In this case set manually according
to the connected equipment.
Auto Power
Saving
With No Input
Lamp Cutoff:
The lamp turns off automatically and
power consumption is reduced if no signal is input for
about 10 minutes.
The lamp lights again when a signal is input or any key is
pressed. In Lamp Cutoff, the ON/STANDBY indicator
lights in orange. (page 53)
Standby
*
13
:
If no signal is input to the unit for about
10 minutes, the power turns off automatically, and the unit
enters standby mode.
Off:
You can deactivate the With No Input.
With Static
Signal
Lamp Dimming
*10 *14 *15
:
If an image does not change
for about 10 seconds, lamp output is gradually reduced
(approximately 10% to 15%*
16
) from that set in the Lamp
Mode. Automatically the lamp slowly darkens to
approximately 30% of its lamp output according to the
selected time (with no change to input signal) “
5
,” “
10
,”
“
15
,” “
20
” minutes or “
Demo
.,” While dimming the lamp,
the message “Lamp Dimming” appears. If you select
“Demo.,” the image will start to darken about 40 seconds
later. When any change in signal is detected, or an
operation (remote control or control panel) is performed,
normal brightness is restored.
Off:
You can deactivate the With Static Signal.
Standby
Mode*
17
Standard/Low:
When set to “Low,” lowers power consumption in Standby
mode.
Direct Power On
On/Off:
When set to “On,” you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet. With
the projector turned off, you can also unplug the AC power cord without
going to Standby mode, regardless of the Direct Power On setting.
Notes
Items
Item descriptions
Содержание VLP-CH350
Страница 82: ...Sony Corporation ...
