VGN-BZ Series Hard Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
2/2
(Use Pre-molded indentation to
initiate cover removal)
Step 4.
To remove the hard drive
access cover lift from the side where
the screw is held in place.
Step 5.
Using the enclosed magnetic
screwdriver,
remove
the one (1)
screw securing the hard drive
assembly.
(HDD must be disconnected)
Step 6.
Locate the black plastic
tab on the hard drive assembly
and gently pull the original hard
drive in the direction shown
above.
Step 7.
Once the hard drive
assembly is disconnected from the
connector carefully lift the hard drive
assembly to remove from hard drive
bay.
(HDD Reinstallation) Steps 8-11
Step 8.
Initiate hard drive re-
installation by sliding the hard drive
assembly back into the hard drive
bay.
(Bracket should be aligned with 2 slots)
Step 9.
Once hard drive is
properly sitting its bay, carefully
re-connect the hard drive to the
connector by sliding the hard
drive in the direction shown
above.
Step 10.
Reinstall the one screw
previously removed.
Step 11.
Reinstall the hard drive
cover and tighten the screw
previously loosened.
Step 12.
Reinstall the Battery
Pack. Reconnect the AC
Adapter.
(Power on your computer
and continue with the recovery
process by following the instructions
described on the back of the
recovery disk’s case.)
Step 13.
Return the old HDD Bay
to Sony following the included
shipping instructions.
P/N
994659300
Rev. A