Sony URX-M2, Руководство по эксплуатации

Страница: 7 / 20

7 Operation
Operation
1
Make all necessary connections on the
tuner.
For examples of connections, see “System
Configurations” on page 12.
2
Turn on the tuner.
The parameters that were in the display
section when the tuner was last turned
off appear again.
Noise will be produced when the tuner
is turned on. Before turning on the
tuner, turn down the volume of the
equipment connected to the tuner.
3
Set the reception channel on the tuner.
Switch the channel on the tuner with
the transmitter turned off and select the
channel where the RF indicator does
not turn on.
For details on setting the reception channel,
see “Setting the reception channel” on page 8.
4
Set the transmission channel on the
transmitter, and then turn off the unit.
For details on setting the transmission
channel, refer to the operating instructions for
the transmitter.
5
Turn on the transmitter.
If noise is heard
Depending on the environment where the
unit is installed, external noise or radio
waves may disrupt transmission on certain
channels.
When selecting a channel under these
circumstances, turn off the transmitter.
Then, on the tuner, select a channel for
which the RF indicator does not light up
(i.e., a channel free from noise or radio
wave interference). Set the same channel on
the transmitter.
To prevent interference or noise, please
take the following precautions.
• Do not use two or more transmitters with
the same wireless channels.
• When operating two or more UWP series
packages simultaneously, set each
package to a different channel within the
same channel group.
• Keep the reception antenna and the
transmitter separated more than 3 meters
(9 feet 11 inches).
• When operating two or more UWP series
packages simultaneously with different
channel groups, make sure that they are at
least 100 meters (330 feet) apart, if they
are used within clear sight of each other.
(The actual distance may differ
depending on the circumstances.)
Note
Note