Sony URX-M2, Руководство по эксплуатации

Страница: 16 / 20

16 Troubleshooting
There is distortion
in the sound. The attenuation level of the
transmitter is too low. The input level of the tuner is
extremely high. Press the + button
on the transmitter in attenuation
level setting mode to raise the
attenuation level.
The transmitter and the tuner
are set to different channels. Set the transmitter to the same
channel.
The compander mode
setting on the transmitter is
different from that on the
tuner. Configure the transmitter’s
compander mode to a setting that
matches this unit.
There is sound
interruption or
noise. The transmitter and the tuner
are set to different channels. Set the transmitter to the same
channel as the tuner.
Two or more transmitters are
set to the same channel. Set each transmitter to a different
channel.
The transmitters are not set
to the channels within the
same channel group. The channel plan which the unit
uses is set so that no signal
interference occurs when 2 or
more transmitters are used
simultaneously. Set each
transmitter to a different channel
within the same channel group.
Two or more UWP series
packages are operated at
close channels. • Select channels within the
same channel group (except
channel group 00).
• Use the channels at least
2-channel intervals (250 kHz).
The RF indications
on the tuner appear
(the RF indicator
lights up) even
when the
transmitter is off. Jamming radio waves are
being received. Locate the channel group that is
unaffected by jamming radio
waves and use that channel
group.
Symptom Meanings Remedy