Sony UP25MD, Инструкция по эксплуатации

Страница: 20 / 76

20
Making Full-Size Image Printouts
O
per
a
tio
n
1
Select INPUT FORM. by pressing the
M
or
m
button.
2
Select the type of the input signal by pressing the
<
or
,
button.
The format of the component signal output from the
RGB/YPbPr/SYNC OUTPUT connector depends on
the component signal selected here.
Note
The INPUT FORM. setting is enabled for SDTV-
signal inputs and outputs. For details about HDTV
signals, see “Configuring HDTV-Signal Inputs and
Outputs” on page 57.
When using SDTV signals, set the SD/HD SEL
setting in the HDTV SETUP menu to SD or AUTO.
(See page 57)
5
Press the MENU button.
The normal screen appears.
Making Full-Size Image
Printouts
This section explains how to make a full-size image
printout. The operations described here constitute the basic
procedure for making a printout.
Before making a full-size image printout
Make sure that the following preparations have been
performed, and refer to the reference pages as necessary.
Make sure to perform these preparations while the printer
is turned off.
• All connections should have already been made. (See
page 12.)
• Ensure that the appropriate ink ribbon/paper set is being
used and that they are correctly loaded. (See pages 15, 17
and 66.)
• Select the input signal to be used to make a printout. (See
page 19.)
• Set the printer to capture one full-size image into
memory. (See page 29.)
• Select the appropriate memory page. (See page 28.)
• Confirm the printout color quality (using, for example,
the LOAD COLOR number). (See page 46.)
1
Turn on the video monitor and the printer.
Signal input to the RGB/YPbPr/
SYNC INPUT connectors Select
RGB input signal RGB
YPbPr input signal YPbPr
Highlight INPUT FORM. in green by
pressing the
M or m button.
Highlight the desired input signal in green
by pressing the
< or , button.
4
3
1
STOP/CLEAR button
DISPLAY button
SOURCE MEMORY button