– 8 –
KV-DA29M81
RM-W105
• REMOVAL OF ANODE-CAP
Note:
• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT
shield or carbon paint on the CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction
indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap firmly in the direc-
tion indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the
anode button, the anode-cap can be removed by
turning up the rubber cap and pulling it up in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with
sharp shaped objects.
2
Do not press the rubber too hard so as not to
damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is
built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage
the rubber.
1-13. PICTURE TUBE REMOVAL
Note:
• Please make sure the TV set is not in standing position before removing necessary CRT support located on
bottom right and left.
• When removing the Nut Locking: first make sure to hold the Nut special CRT with a spanner while opening the Nut
Locking using a torque driver. Then proceed to remove the Nut special CRT using a torque driver.
1) Place the TV set with the CRT face down on a cushion (jig).
2) Removal the Rear Cover.
3) Unplug all interconnecting leads from the Deflection Yoke, Neck Assy, Degaussing Coils and CRT grounding strap.
!∞
Earth Coating Assy
5
Degaussing Coil
4
Anode Cap Removal
7
C Board Removal
8
VM Board Removal
9
Chassis Assy Removal
!£
Spring Tension(2)
Removal
!™
Support, CRT Removal (x2)
!¢
Holder, DGC
Removal (x2)
!§
Screw, Tapping 7 +
Crown Washer (4)
!º
Loosen the Deflection Yoke
fixing screw and remove
!¶
Band, DGC Removal
6
Loosen the Neck Assembly
fixing screw and removal
a
a
b
b
c
Anode Button