Sony Trinitron KV-28DX30U, Руководство по эксплуатации

Страница: 17 / 40

13
Additional TV Features
Before listening to Dolby Surround encoded programmes, you can adapt the features of Dolby Pro Logic to suit your own taste.
Note: Dolby Pro Logic decoding should only be turned on when external centre and/or surround speakers are connected. Sony
recommend that the centre and/or surround speakers should only be SS-CR190 or equivalent.
There will be no output available from the headphones or the audio output socket
on the rear of the TV when Dolby Pro Logic
has been selected.
Setting up Dolby Pro Logic
1. Press the MENU button on the remote control to display
the menu on the TV screen.
2. Press the
V
or
v
buttons to select the symbol on the
menu screen then press the
b
button to enter the
‘PRESET’ menu.
3. Press the
V
or
v
buttons to select ‘Surround Mode Setup’
on the menu screen then press the
b
button to enter the
‘SURROUND MODE SETUP’ menu.
4. Press the
V
or
v
buttons to select ‘Surround Mode’, then
press the
b
button to enter. Press the
b
or
B
buttons to
select one of the following modes then press the OK
button to store the chosen mode:
Pro Logic: all 5 speakers are activated
3 stereo: surround speakers are not used
Virtual: no external speakers required. Do not select this
mode if you wish to receive Dolby Pro logic
5. Press the
v
button to select ‘Centre Mode’, then push the
b
button to enter. Press the
b
or
B
buttons to select one
of the following modes then press the OK button to store
the chosen mode:
Normal: all 5 speakers are activated
Wide: wider bandwidth for centre speaker
Phantom: centre speaker is not used (This cannot be
selected if you have chosen “3 stereo” mode in step 4)
6. Press the
v
button to select ‘Test Tone’ then push the
b
button to enter. Press the
b
or
B
buttons to select ‘On’,
then press the OK button.
The test tone will cycle through all the speakers.
7. Press the
v
button to select the ‘Left Speaker’, then press
the
b
button to confirm. The tone remains at the left
speaker.
8. Press the
V
or
v
buttons to alter the sound level, then
press the OK button.
9. Repeat steps 7 and 8 to select and adjust the ‘Centre’,
‘Right’, and ‘Surround’ speakers, so that the sound output
from all speakers are balanced in relation to your sitting
position.
10. Press the MENU button to remove the display.
Note: After setting up Dolby Pro Logic, refer to the ‘Adjusting the sound’
section on page 11 and set the Surround Mode to Pro Logic.
RM-888
MENU
PROGR
OK