Getting Started
Getting Started
5
3. Connecting an aerial and a VCR
1
Connect your existing aerial lead to the Digital socket
marked
on the rear of the TV as shown.
2
Connect the supplied RF loopthrough cable from the
sockets marked
to the Analogue socket marked
.
1
Connect your existing aerial lead to the Digital socket
marked
on the rear of the TV as shown.
2
Connect the supplied RF loopthrough cable from the
aerial socket marked
on the TV to the RF input
socket of your VCR.
3
Connect a lead from the RF output of your VCR to
the Analogue TV socket marked
.
4
Connect a scart lead from the scart socket marked
on the rear of the TV to a scart socket on
your VCR (Refer to the VCR instructions).
5
Connect the VCR to the mains socket and switch on.
6
Insert a pre-recorded tape into the VCR and press
the ‘PLAY’ button. This enables the TV set to locate
and store the video channel during the ‘Automatically
tuning the TV’ procedure.
3/
s
3
4. Switching on the TV
1
Connect the TV plug to your mains socket (220 -
240V AC, 50 Hz) and switch on.
2
Push in the On/Off button (
) on the front of the TV.
If the red standby mode indicator on the front of the
TV is lit, press the TV
button on the remote
control to switch on the TV set. Please be patient as
the picture may take a few moments to appear on the
TV screen.
/
Existing aerial lead
RF Loopthrough
cable (supplied)
Connecting an aerial only
Scart lead
(not supplied)
Rear of VCR
RF Loopthrough
cable (supplied)
Existing aerial lead
Connecting an aerial and a VCR
RF Lead
(not supplied)
On/Off button
DX100 Pages 1-10.fm Page 5 Tuesday, September 18, 2001 11:12 AM