15
EN
Getting Started
Basic Operations
4
Start recording on the recording deck and then
start playing the component.
Notes
• The signal input from a digital jack is not output to the
analog RECOUT jacks. To do analog recording, be sure to
connect the component to the analog input jacks.
• Sound adjustments do not affect the signal output from
the DAT/MD OUT OPTICAL, DAT/MD RECOUT, and
TAPE RECOUT jacks.
Recording on a video tape
You can record from a VCR, a TV, or an LD player
using the amplifier. You can also add audio from a
variety of audio sources when editing a video tape. See
your VCR or LD player’s instruction manual if you
need help.
1
Select the program source to be recorded.
2
Set the component to be ready for playing.
For example, insert the laser disc you want to
record from into the LD player.
3
Insert a blank video tape into the VCR (VIDEO 1
or VIDEO 2) for recording.
4
Start recording on the recording VCR and then
start playing the video tape or laser disc you want
to record.
z
You can record sound from a different audio source
onto a video tape while copying from a video tape
or laser disc
Locate the point where you want to start recording from
another audio source, select the program source, then
start playback. The audio from that source will be
recorded onto the audio track of the video tape instead
of the audio from the original.
To resume audio recording from the original, select the
video source again.
Notes
• You cannot record audio from a program source
connected to the LD IN AC-3 RF, LD IN OPTICAL, or LD
IN COAXIAL jack.
• Sound adjustments do not affect the signal output from
the VIDEO 1/2 AUDIO OUT jacks.
Using the Sleep Timer
Z
You can set the amplifier to turn off automatically at a
time you specify.
SLEEP
2
1
3
LEARN
SLEEP
VISUAL
POWER
SYSTEM OFF
SLOPE
BAND
EQ/
TONE
DIGTAL
PROCESSING
CONTROL
PROGRAMMABLE
— LEVEL —
DIRECT
REAR
BASS
BOOST
MUTING
CENTER
MASTER
VOL
MODE
GENRE
— SOUND FIELD —
ON/OFF
TEST
TONE
TV
CONTROL
5.1
INPUT
5
4
6
TV/VIDEO
8
7
9
D.TUNING
DISC
0
BACK
GROUND
SHIFT
ENTER
RMS/START
CH/
PRESET
SYSTEM CONTROL / FUNCTION
VIDEO 3
VIDEO 2
VIDEO 1
LD
TV
(AUTO CATEGORIZE SYSTEM)
CD
DAT/MD
>
10
TAPE
ON
TUNER
PHONO
+
+
–
–
+
–
POSITION
–
SUB CH
+
— RMS —
SWAP
ANT
TV/VTR
=
)
0
+
D. SKIP
CLEAR
DIRECTION
P IN P
JUMP
p
(
DPC
MODE
9
P
r
Press SLEEP on the remote while the power is on.
Each time you press SLEEP, the time changes as shown
below.
n
2:00:00
n
1:30:00
n
1:00:00
n
0:30:00
n
OFF
The display dims after you specify the time.
z
You can freely specify the time
Press SLEEP first, then specify the time you want using
the digital processing control buttons (
or
). The
sleep time changes in 1 minute intervals. You can
specify up to 5 hours.
z
You can check the time remaining before the
amplifier turns off
Press SLEEP. The remaining time appears in the
display.
