8
US
SONY TA-MR2ES (US) 2-514-603-12(1)
Chapter 2
Setting up the
amplifier
This chapter provides you with
information on the amplifier
regarding installation, hookups and
settings.
Installing the amplifier
7 inches (177.8 mm) minimum
2 inches (50.8 mm)
minimum
When you mount the amplifier, note the following:
• Place the amplifier on a flat and level surface.
• When installing it in a cabinet, make sure the back of
the cabinet is open to allow adequate ventilation,
prevent heat buildup, and prolong the life of the unit.
• Place a board under the amplifier if it is located on a
carpet to allow adequate ventilation on the bottom.
• Make sure the weight is equally distributed on each of
its four feet.
• Do not place anything on the top of the amplifier that
might block the ventilation holes and cause
malfunction.
• Do not place anything on the front or rear panel that
might damage the amplifier’s control buttons and
connectors.
• Use caution when placing the unit on surfaces that have
been specially treated (with wax, oil, polish, etc.) as
staining or discoloration of the surface may result.
Leave at least 3 inches (76.2 mm) on each side for
ventilation.
01US04CH2-U.p65
11/30/04, 1:08 PM
8
